Omron ZW-8000 Series User Manual page 108

3
Select the trigger target.
Item
Trigger target
106
Displaying measured values in graphs
Setting item Range
I/O TIMING
ZERO
BUSY
ENABLE
HIGH
PASS
LOW
TASKSTAT
LOGGING
LOGSTAT
LOGERR
STABILITY
RESET
LIGHT_OFF
BUFFER_ERR
Data slope OUT1
Data window (in)
OUT2
Data window (out)
OUT3
OUT4
Description
TIMING input signal (parallel I/O)
ZERO input signal (parallel I/O)
BUSY output signal (parallel I/O)
ENABLE output signal (parallel I/O)
HIGH output signal (parallel I/O)
PASS output signal (parallel I/O)
LOW output signal (parallel I/O)
TASKSTAT output signal (parallel I/O)
LOGGING input signal (parallel I/O)
LOGSTAT output signal (parallel I/O)
LOGERR output signal (parallel I/O)
STABILITY output signal (parallel I/O)
RESET output signal (Parallel I/O)
LIGHT_OFF input signal (parallel I/O)
Turn ON when dropping occurs.
Dropping may occur depending on the load factor of PC
when acquiring data from ZW-8000/7000/5000 series. If
dropping occurs, increase the arguments of logging.
Measurement results assigned to OUT1
Measurement results assigned to OUT2
Measurement results assigned to OUT3
Measurement results assigned to OUT4
ZW-8000/7000/5000
User's Manual