Omron ZW-8000 Series User Manual page 246

Setting the Frequency Filter
Setting the Frequency Filter p.155
As an example, here is an explanation of the procedure for selecting the "LOPASS" setting for the frequency
filter type, and the "1Hz" cut-off frequency filter setting.
Operating procedure
Steps Key operation
1 to 4 For moving to "FILTER", see steps 1 to 4 in p.242.
5
6
7
8
9
244
Setting the Output Conditions
Display Description
Select "FRQNCY" as the filter type.
Press the
key.
Select the frequency filter type.
LO.PASS: LOWPASS FILTER
HIPASS: HIGHPASS FILTER
BD.PASS: BANDPASS FILTER
Select "LOPASS" as the frequency filter type.
The current setting value is displayed on the sub-display.
Press
In this example, select "LO.PASS" and press the
Set the cut-off frequency.
"CUTOFF" is displayed on the main display and the current setting
value is displayed on the sub-display.
Press
blinks.
To edit numerical values, use the
In this example, input "1", then press the
The decimal point is displayed.
Press the
Determine the decimal point and then press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
/ keys to select "FREQ" and press the
/ key to enter editing mode and the sub-display blinks.
key to enter the editing mode, and the sub-display
/
/ key to move the decimal point.
key for two seconds or more to enter the
key.
/ / keys.
key.
key.
ZW-8000/7000/5000
User's Manual