Omron ZW-8000 Series User Manual page 249

Steps Key operation
9
Automatically Setting Scaling
Performing 1-point Scaling
Performing 1-point Scaling p.144
Operating procedure
Steps Key operation
1 to 5 For moving to "SCALE", see steps 1 to 5 in p.246.
6
7
8
9
10
11
12
ZW-8000/7000/5000
User's Manual
Display Description
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
Display Description
Select "AUTO" as the scaling type.
The current setting value is displayed on the sub-display.
Press
Select "AUTO" and press the
Select "1POINT".
Press the
Press the
The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
To edit numerical values, use the
Enter the setting value and then press the
Set the increment/decrement direction.
"DIRECT" is displayed on the main display and the incremental/
decremental directions ("FWD": the NEAR side as + and "REV": the
FAR side as +) are displayed on the sub-display.
Press
Enter the setting value and then press the
"OK/CAN" is displayed on the sub-display.
Press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
key for two seconds or more to enter the
/ key to enter editing mode and the sub-display blinks.
key.
/ keys to select "1PT" and press the
key when the main display shows "POINT1".
/
/ key to enter editing mode and the sub-display blinks.
key to execute scaling or
key for two seconds or more to enter the
Setting the Output Conditions
key.
/ / keys.
key.
key.
key to cancel.
247