Omron ZW-8000 Series User Manual page 251

Multi-point scaling (ZW-8000@ only)
Multi-point scaling p.148
Operating procedure
Steps Key operation
1 to 5 For moving to "SCALE", see steps 1 to 5 in p.246.
6
7
8
9
10
11
12
13
14
ZW-8000/7000/5000
User's Manual
Display Description
Select "AUTO" as the scaling type.
The current setting value is displayed on the sub-display.
Press
Select "AUTO" and press the
Press the
Press the
Set the measured value of point 1.
The current measured value is displayed on the main display and the
current setting value is displayed on the sub-display.
To edit numerical values, use the
Enter the setting value and then press the
Press the
Set the measured value of point 2.
To edit numerical values, use the
Enter the setting value and then press the
"OK/CAN" is displayed on the sub-display.
When continuing to set the next point measurement value, press the
When ending all point measurement value settings, press the
Repeat steps 10 to 12 until reaching a maximum of point 10.
When pressing the
completes, "OK/CAN" is displayed on the sub-display.
When continuing to set the next point measurement value, press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
/ key to enter editing mode and the sub-display blinks.
key.
/ keys to select "NPT" and press the
key when the main display shows "POINT1".
/
key when the main display shows "POINT2".
/
key.
key.
key in step 12 or point 10 setting
key. When ending all point settings, press the
key for two seconds or more to enter the
Setting the Output Conditions
key.
/ / keys.
key.
/ / keys.
key.
key.
249