Steps
Key operation
8
9
10
11
12
13
14
15
236
Setting Sensing
Display
Description
Set "200".
The current setting value is displayed on the sub-display.
The sub-display blinks and the system enters editing mode.
To edit numerical values, use the
Input "200", then press the
Set the edge 3 track width.
Press the
key.
Set "300".
The current setting value is displayed on the sub-display.
The sub-display blinks and the system enters editing mode.
To edit numerical values, use the
Input "300", then press the
Set the edge 4 track width.
Press the
key.
Set "400".
The current setting value is displayed on the sub-display.
The sub-display blinks and the system enters editing mode.
To edit numerical values, use the
Input "400", then press the
Execute TEACH.
Press the
"OK/CAN" is displayed on the sub-display.
Press the
When teach is successful, "LCK.OK*" is displayed.
When teach fails, "LCK.ERR" is displayed.
Make sure the measurement surface is present and execute teach
again.
When the measurement surface is present, the STABILITY indicator
is lit during RUN mode. ?
* The successful edge count is displayed. If edges 1 through 3 are
successful, "LCK.3OK" is displayed.
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
/
/
key.
/
keys to select "TR.WID3" and press the
/
/
key.
/
keys to select "TR.WID4" and press the
/
/
key.
key.
key to execute teaching or
key for two seconds or more to enter the
/
keys.
/
keys.
/
keys.
key to cancel.
ZW-8000/7000/5000
User's Manual