Omron ZW-8000 Series User Manual page 170

3
Enter [Delay time] and [Sampling time].
Important
• Set so that the "delay time + sampling time" is
shorter than the TIMING input interval. When
the TIMING input turns ON again before the
"delay time + sampling time" elapses, the
TIMING input that is input later is ignored and is
not reflected in sampling.
• The delay time and sampling time is rounded up
by the measurement cycle unit.
• When 2 area mode is selected, the minimum
values of the delay time and sampling time are
twice as long as the measurement cycle.
Note
The trigger delay can also be set by the operating keys on the Sensor Controller.
Setting a Trigger Delay p.254
168
Setting the Output Conditions ZW-8000/7000/5000
User's Manual