Omron ZW-8000 Series User Manual page 179

Setting the non-measurement conditions
The measurement value can be set to the clamp value when there is an unexpected number of edges or
reflection power due to the state of the light reception waveform.
At this time, "------" is displayed on the controller's main display.
* With ZW-7000@/5000@, this setting is not possible.
Setting item Setting value
Reflection power ON/OFF
Reflective power 1 to 1000
threshold
Number of Edge ON/OFF
Condition for surface/ 2 surface /3 surface /4 surface /Edge 5 or more
number of Edge
Comparison (Condition for number of Edge) = (Observed number of Edge)/
(Condition for number of Edge) ≤ (Observed number of Edge)/
condition of
(Condition for number of Edge) ≥ (Observed number of Edge)
number of Edge
1
Set the operating mode to the FUNC mode.
3-2 Switching operation modes p.98
 Multi View Explore
→ Edit pane
→ I/O Setting Screen
2
Set the condition of the non-measurement
value at [Non-Measuring Specification].
3
Set [Reflective power threshold], [Condition for number of Edge] and [Comparison condition of
number of Edge].
ZW-8000/7000/5000
User's Manual
: [Bank Group] | [(Bank Data Name)] (double click)
: [I/O Settings] icon (
: [Non-Measuring Specification]
Description
When set to ON, the measurement value
is set to the clamp value when less than
the set reflection power threshold.
Set the reflection power threshold value.
Reflection power is the strength of light
returning from the workpiece.
When set to ON, if the set edge number
condition is not met, the measurement
value is set to the clamp value.
Set the edge number condition.
Set the edge number comparison
condition.
)
177
Setting I/O