Functions Of Operating Keys - Omron ZW-8000 Series User Manual

7-3 Functions of Operating Keys

The following table lists the names and functions of the operating keys on the Sensor Controller:
Name
← (LEFT) key
→ (RIGHT) key
↑ (UP) key
↓ (DOWN) key
Mode switching key
ZERO/SET key
ZERORST/ESC key
222

Functions of Operating Keys

Function
RUN (operation) Mode
Changes sub-display content.
key: Executes TIMING input.
key: Executes RESET input.
* These keys are available only if key
inputs for the hold functions have
been enabled in the FUNC mode.
Performing Hold with
a Key Input p.166
Press and hold for two seconds or
more to enter FUNC mode.
• For operating mode switching,
"SWITCH" is displayed on the
main display and "OK/CAN" is
displayed on the sub-display.
Press the ZERO/SET key to
switch the mode.
If you press for less than two
seconds, the display shifts to RUN
mode task switching and the
threshold value setting menu.
Executes a zero reset.
Hold down for at least two seconds
to cancel a zero reset.
FUNC (adjustment) Mode
Functions differently depending on the settings.
• Function display switching
• Numerical value digit selection
• Setting cancellation
Functions differently depending on the settings.
• Selection menu switching
• Setting value selection
Press and hold for two seconds or more to enter
RUN mode.
• For operating mode switching, "SWITCH" is
displayed on the main display and "OK/CAN" is
displayed on the sub-display. Press the ZERO/
SET key to switch the mode.
• When the mode is switched from FUNC mode
to RUN mode, "SAVE" is displayed on the main
display and "OK/CAN" is displayed on the sub-
display.
Press the ZERO/SET key to save the settings
and switch the operating mode.
Press the ZERORST/ESC key to switch the
operating mode without saving the settings.
If you press for less than 2 seconds, the display
shifts to RUN mode task switching and the
threshold value setting menu.
Also, this starts teaching to set threshold values
when setting a threshold value.
Functions differently depending on the selections.
• Application of selection conditions and numeri-
cal values
• Switching to lower menus
Functions differently depending on the selections.
• Cancellation of selection conditions and numer-
ical values
• Switching to upper menus
Hold down for at least two seconds to jump to the
top menu on the FUNC mode.
ZW-8000/7000/5000
User's Manual