Changing Between Online And Offline - Omron ZW-8000 Series User Manual

6-3 Changing between Online and Offline

Before you go offline, save all settings and parameter changes to the Sensor's internal memory. Saving your
project does not save the data in the Sensor.
You can use the following two methods to change between offline and online.
 Multi View Explore
 Multi View Explore
→ Edit pane
1
To go offline, click [Disconnect]. To go
online, click [Connect].
2
When you click [Connect], the Sensor
Controller with the specified IP address is
connected. When the connection is
successful, Sensor Controller information is
displayed.
3
When you click [Connect], you must
synchronize the data between the Sensor
and the project.
When a project setting data is synchronized with
Sensor Controller, select [Transfer to Sensor].
When synchronize a Sensor Controller's setting
data with project, select [Transfer from Sensor].
Note
Saving the Bank/System Settings p.185, p.263
Saving a project p.93
Important
When Sysmac Studio and the sensor controller bank mode (refer to
current bank number after project data synchronization is set to the initial value (1).
204

Changing between Online and Offline

: [(Sensor Name)] (right click)| [Online]/[Offline]]
: [Device group] | [(Sensor model)] (Double-click)
: [Online] Icon | [Sensor connection] | [Connect] or [Disconnect]
Clearing the Bank Settings p.188) differ, the
ZW-8000/7000/5000
User's Manual