Omron ZW-8000 Series User Manual page 255

Performing Hold with a Key Input
Press the / key on the Sensor Controller to enable the TIMING or RESET input.
• TIMING input is ON while the
•
• RESET input is ON when the
Note that the key input is disabled in the default setting. Set the following when using this function.
Steps Key operation
1
2
3
4
5
Note
The above settings are also possible using the personal computer tools.
Performing Hold with a Key Input p.166
ZW-8000/7000/5000
User's Manual
key is pressed.
key is pressed.
Display Description
Press and hold the
FUNC mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
Press the
key.
Press the
key.
Enable the key input.
The current setting value is displayed on the sub-display.
Press
Select "ON" and press the
Press and hold the
RUN mode.
To save the setting, refer to "7-3 Functions of Operating Keys"
(p.222).
key for two seconds or more to enter the
/ keys to select "SYSTEM" and press the
/ keys to select "KEY.IN" and press the
/ key to enter editing mode and the sub-display blinks.
key.
key for two seconds or more to enter the
Setting the Output Conditions
253