Wiring Example For The Factory Settings - Siemens SINAMICS G110M Operating Instructions Manual

Installation
4.3 Electrical Installation
To make the setting process easier, the converter has various predefined assignments (macros).
Only the inputs and outputs whose functions change by selecting a specific assignment, are
shown on the following pages.
Procedure
1. Think about which of the input and output functions you are using in the application.
2. Find the I/O configuration (macro) that best suits your application.
3. Note the macro number of the corresponding default setting.
You must set this macro number when putting the frequency converter into operation.
You have found the appropriate converter pre-assignment.
❒
4.3.10

Wiring example for the factory settings

To ensure that the factory setting of the interfaces can be used, you must wire your drive as
shown in the following examples.
Factory pre-assignment of the interfaces on the drive
For a complete technical specification of the individual connections, please refer to following
section of this manual:
Figure 4-16
80
Connection and cables (Page 67)
Macro 29 - Conveyer with potentiometer and fixed setpoint (Default USS)
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL