6.1.3
Wiring examples for the factory settings
To ensure that the factory setting can be used, you must wire the terminal strip of your
converter as shown in the following examples.
Factory pre-assignment of the terminal block at the converter with RS485 field bus interface
Figure 6-2
Note
Assignment of terminals following basic commissioning
The assignment of the terminal strip does not change once you have performed the basic
commissioning procedure.
SINAMICS G120C frequency converter
Operating Instructions, 03/2012, FW V4.5, A5E02999804B AB
Default wiring using RS485 communications
Basic commissioning
6.1 Preparing basic commissioning
53