Siemens SINAMICS G110M Operating Instructions Manual page 100

Installation
4.4 Connecting the converter to the fieldbus
3.
4.
Changing existing addresses of the AS-i slaves
If the allocated addresses used two different numbers, for example, 10A and 11A, then if one of
the slave addresses is reset to 0 the other slave is not affected.
If the allocated addresses use the same number, for example, 20A and 20B, then if one slave
addresses is reset to 0, then both slaves numbers will be reset to 0.
Modifying an existing address of a single slave within the converter will not affect the address of
the other slave.
To change an existing address of a slave, the following procedure should be performed:
1.
2.
3.
4.
5.
6.
7.
98
Press the button until you reach the required number.
By pressing both the
identifiers of the address.
Press the button to accept this number.
ProG is displayed briefly.
Both of the numbers allocated to the slaves are now displayed in the
lower part of the screen.
Plug the AS-i Programmer into the addressing socket of the converter
Turn the dial on the Programmer to the ADDR position. The display
will indicate that this mode has been selected.
Press the button; the screen will display uSE and the number of
the lower addressed slave.
The existing slave addresses are shown at the bottom of the display.
Press the and
Press the button; the display now shows SEt.
The selected number will begin to flash.
Press the and
ber.
Press the button to confirm the new address.
ProG is displayed briefly followed by confirmation of the address
change.
and simultaneously, you can toggle between A and B
buttons to select the slave address number to be changed.
buttons to select the new slave address num‐
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
Distributed converter for SIMOGEAR geared motors