Siemens SINAMICS G110M Operating Instructions Manual page 84

Installation
4.3 Electrical Installation
Default settings for the CU240M
The default settings that are available for the CU240M Control Modules are shown in the figures
below. Default settings 7 is the default setting for the CU240M DP and CU240M PN Control
Modules, default settings 21 is the default settings for the CU240M USS Control Module and
default settings 30 is the default settings for the CU240M ASi Control Modules.
Figure 4-19
Figure 4-20
Figure 4-21
82
Default settings 7 - Switch over between fieldbus and jogging using DI 3 (default DP/PN)
Default settings 9 - Motorized potentiometer (MOP)
Default settings 12 - Two-wire control with method 1
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL