Siemens SINAMICS G110M Operating Instructions Manual page 109

3. Set p0301 = 0 (This disables the automatic motor data assignment).
4. Complete the commissioning process, entering the motor data (from the motor rating label)
into the relevant parameters.
5. Set p3900 = 1, 2 or 3 to end quick commissioning, depending on the users requirements.
Parameter p0301 must be set to 0
When commissioning using the manual input of motor data, it is important that p0301 is set
to 0.
If p0301 is not set to 0, then even if the motor ID function is selected at the completion of the
commissioning process, no motor ID will actually be performed. If the motor ID is not
performed it could leave the motor in an unpredictable state and that may adversely affect the
users application.
Therefore, it is essential that p0301 is checked to ensure it is actually set to 0.
Commissioning with the Intelligent Operator Panel (IOP)
When using the basic commissioning wizard on the IOP the user will presented with a screen
asking for the motor type (p0300) to be entered. Depending on the value that is input into the
IOP, there are two different branches to the commissioning wizard.
Action 1(using motor codes):
1. If 100 or 177 is entered, the user is then presented with the motor code screen (p0301).
2. Entered the relevant code for the motor.
3. The motor data is automatically assigned for the motor.
4. The basic commissioning wizard continues but does not ask for any further motor data to be
entered.
Action 2 (no motor codes):
1. If 1 is entered (Induction motor), the IOP will automatically set p0301 to 0.
2. The basic commissioning wizard continues and asks for the relevant motor data to be entered
during the commissioning process.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
CAUTION
Commissioning
5.4 Quick commissioning
107