Siemens SINAMICS G110M Operating Instructions Manual page 362

Alarms, faults and system messages
9.7 List of alarms and faults
Number Cause
F07902 Motor stalled
A07903 Motor speed deviation
A07910 Motor overtemperature
A07920 Torque/speed too low
A07921 Torque/speed too high
A07922 Torque/speed out of tolerance
F07923 Torque/speed too low
F07924 Torque/speed too high
A07927 DC braking active
A07980 Rotary measurement activated
A07981 No enabling for rotary measurement Acknowledge pending faults.
A07991 Motor data identification activated
F08501 Setpoint timeout
F08502 Monitoring time sign-of-life expired •
F08510 Send configuration data not valid
A08511 Receive configuration data not valid
A08526 No cyclic connection
A08565 Consistency error affecting adjusta‐
ble parameters
F13100 Know-how protection: Copy protec‐
tion error
F13101 Know-how protection: Copy protec‐
tion cannot be activated
360
Remedy
Check whether the motor data has been parameterized correctly and per‐
form motor identification.
Check the current limits (p0640, r0067, r0289). If the current limits are too
low, the drive cannot be magnetized.
Check whether motor cables are disconnected during operation.
Increase p2163 and/or p2166.
Increase the torque, current and power limits.
Check the motor load.
Check the motor's ambient temperature.
Check the KTY84 or Pt1000 sensor.
Check the overtemperatures of the thermal model (p0626 ... p0628).
The torque deviates from the torque/speed envelope curve.
• Check the connection between the motor and the load.
• Adapt the parameterization corresponding to the load.
• Check the connection between the motor and the load.
• Adapt the parameterization corresponding to the load.
Not required
Not required
Establish missing enables (see r00002, r0046).
Switch on the motor and identify the motor data.
• Check the PROFINET connection.
• Set the controller to RUN mode.
• If the error occurs repeatedly, check the set monitoring time p2044.
Check the PROFINET connection.
• Check the PROFINET configuration
• Activate the controller with cyclic operation.
• Check the parameters "Name of Station" and "IP of Station" (r61000,
r61001).
Check the following:
• IP address, subnet mask or default gateway is not correct.
• IP address or station name used twice in the network.
• Station name contains invalid characters.
The know-how protection and the copy protection for the memory card are
active. An error occurred during checking of the memory card.
• Insert a suitable memory card and switch the converter supply voltage
temporarily off and then on again (POWER ON).
• Deactivate the copy protection (p7765).
Insert a valid memory card.
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
Distributed converter for SIMOGEAR geared motors