Table of Contents
Advertisement
Stand-alone node setup
............................................................................................................................................................................................................................................................
Circuit pack installation
Description
This section provides instructions and the recommended order for installing (fully seating)
the circuit packs in the Alcatel-Lucent 1850 TSS-60 shelf. The procedures in this section
assume that the SYSCTL is installed and operational.
Locations of circuit packs (function unit slots) are shown in
1850 TSS-60 shelf" (p.
Circuit packs are keyed to prevent being inserted into the wrong shelf position. Installing
circuit packs requires some force.
When a circuit pack is installed, its
extinguish.
A properly grounded ESD wrist strap MUST be worn when handling circuit packs.
Note:
require a pointed object.
............................................................................................................................................................................................................................................................
5 - 4
4-9).
CAUTION
When installing the circuit packs, be careful to insert them straight to avoid
damaging the backplane pins.
CAUTION
ESD hazard
CAUTION
Laser Safety
When connecting fiber loops between the IN and OUT ports on optical circuit
packs, always connect to the IN port first and then the OUT port. This will
prevent any optical radiation from being present at the fiber end.For more
detailed information and safety precautions, refer to
The UPD/INIT pushbutton on the SYSCTL circuit pack is recessed and will
LED will light for several seconds then
FAULT
Circuit pack installation
Figure 4-2, "Alcatel-Lucent
Chapter 1,
"Safety".
365-372-603R2.0
Issue 1 January 2009
Advertisement
Table of Contents
