Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
LNW40, LNW140, LNW601, LNW38, LNW51, LNW380, LNW41, LNW141 or
•
LNW84
........................................................................................................................................................................................................................
1
Establish a CIT session by following the procedure under
software" (p.
........................................................................................................................................................................................................................
2
Click on the
........................................................................................................................................................................................................................
3
Select
........................................................................................................................................................................................................................
4
Select
Click
Result:
........................................................................................................................................................................................................................
5
Verify the active path, with the
Result:
when selected.
........................................................................................................................................................................................................................
6
Disconnect the optical fiber connected to the OUT port of the OLIU that is the active
receiver.
Result:
LED should flash on the OLIU.
........................................................................................................................................................................................................................
7
Verify the active path, with the
Result:
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
5-8).
View -> Cross-Connections
Shelf
.
to issue the command.
The cross-connects entered previously should still be in place.
Each cross-connect that was entered will have an active path associated with it
CAUTION
Equipment damage
The LNW38, LNW40, LNW51, LNW140, LNW380 and LNW601 OLIU circuit
packs are equipped with optics that do not meet GR-78 R9-3 requirements on
ESD susceptibility. Always use proper ESD procedures when handling these
OLIU circuit packs to avoid equipment damage.
The MN and then NE alarm LED should light on the SYSCTL and the FAULT
The active path has now switched to the other path.
Automatic protection switching and alarm test
.
View -> Protection -> Path Protection
View -> Protection -> Path Protection
®
"Use of WaveStar
CIT
command.
command.
6 - 4 9
Advertisement
Table of Contents
