Use Of Wavestar ® Cit Software - Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual

Stand-alone node setup
............................................................................................................................................................................................................................................................
Use of WaveStar
Description
Complete the following steps to login to the Alcatel-Lucent 1850 TSS-60 via WaveStar
CIT. It is assumed that the CIT software has been installed on the PC and the LNW2
system controller is installed and operational to the Alcatel-Lucent 1850 TSS-60 shelf per
the Software Release Description.
Login procedure
Proceed as follows:
........................................................................................................................................................................................................................
1
Connect the PC serial port to the RS-232 port of the SYSCTL circuit pack with a serial
RS-232 cable
to the front LAN port of the SYSCTL circuit pack with a RJ45 to RJ45 cross-over cable
Table 3-14, "LAN 10Base-T straight-through cable connections" (p.
........................................................................................................................................................................................................................
2
Start the WaveStar
was created by the installation procedure.
The following windows should appear:
............................................................................................................................................................................................................................................................
5 - 8
®
CIT software
[Table 3-23, "CIT cable assembly" (p.
®
CIT software on the PC by double clicking on the WaveStar
Use of WaveStar
3-73)]. Or connect the PC LAN port
3-49).
Issue 1 January 2009
®
CIT software
®
®
icon that
365-372-603R2.0