............................................................................................................................................................................................................................................................

Part II: "Stand-alone installation testing"

Part II covers Chapters 5 and 6. These sections cover the initial Graphical User Interface

(GUI) or Craft Interface Terminal (CIT) software installation and turn-up testing on a new

Alcatel-Lucent 1850 TSS-60 shelf. It is intended to verify correct electrical DS1/DS3/FE

cable wiring to the DSX panel or punch down block as well SONET fiber routing to the

LGX panel from the faceplates of installed packs. This section also the recommended

checklist

Transport Service Switch 60 (TSS-60) system. Use of the installation checklist is required

to ensure a quality installation. All completed tasks should be checked off and those not

completed should be duly noted as to the reason why. This checklist should be turned in as

part of your job complete paperwork.

Chapter 5, "Stand-alone node setup"

This chapter provides procedures for initial Graphical User Interface (GUI) or Craft

Interface Terminal (CIT) software installation and circuit packs provided via work order.

Also, the use of the Graphical User Interface (GUI) or Craft Interface Terminal (CIT).

Chapter 6, "Stand-alone installation testing"

This chapter is to verify proper transmission cabling installation and Release 2.0

functionality as well as the associated functionality of the Alcatel-Lucent 1850 TSS-60

shelf.

Part III: "Network turn-up and testing"

Part III covers fiber connections between nodes in a ring. It is not intended to replace

acceptance test procedures. This section also provides the recommended checklist

"Installation checklist"

Use of the installation checklist is required to ensure a quality installation. All completed

tasks should be checked off and those not completed should be duly noted as to the reason

why. This checklist should be turned in as part of your job complete paperwork.

Chapter 7, "Connecting adjacent network elements"

This chapter is used to make fiber connections between nodes in a ring. It is not intended

to replace acceptance test procedures.

Part IV: "Miscellaneous detailed installation procedure and reference material"

Part IV provides supplementary information that is useful when installing the

Alcatel-Lucent 1850 TSS-60 system and using this Installation Manual.

365-372-603R2.0

Issue 1 January 2009

"Installation checklist"

to follow when installing a Alcatel-Lucent 1850 TSS-60 system.

to follow when installing a Alcatel-Lucent 1850

x i i i

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 13

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents