Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
9
Verify the active path, with the
Result:
a ABN condition will be displayed on the GUI.
........................................................................................................................................................................................................................
10
Clear the manual switch.
........................................................................................................................................................................................................................
11
Click on the
........................................................................................................................................................................................................................
12
Double Click on a path; e.g.,
........................................................................................................................................................................................................................
13
Observe the
........................................................................................................................................................................................................................
14
Protection Switch Mode
In the
........................................................................................................................................................................................................................
15
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
Function units/growth slots switching test
This test will initiate switching commands from the CIT and verify proper switching and
LED indications.
Note:
pair.
........................................................................................................................................................................................................................
1
Use the e
........................................................................................................................................................................................................................
2
Click on the
........................................................................................................................................................................................................................
3
Click on
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
The path selected in the previous steps will have switched to the other path and
Fault -> Protection Switch -> Path Protection
Path m-1-1
Active Path
displayed.
S
F
T E P S
This procedure should be performed on each function unit and/or growth slot
GUI
to view the equipment state command.
View -> Equipment
CP fn-d-1 or fn-g-1
View -> Protection -> Path Protection
.
pull down window select
"Installation checklist" (p.
.
Select.
and click
Manual switching tests
command.
.
Clear
.
II-5).
6 - 5 3
Advertisement
Table of Contents
