Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
Manual switching tests
Description
This test will initiate switching commands from the WaveStar
switching and LED indications.
Main OLIU switch test
Note:
........................................................................................................................................................................................................................
1
Use the
........................................................................................................................................................................................................................
2
Verify the active path, with the
Result:
when selected. The M1 OLIU is associated with Ring 1 and the M2 OLIU is
associated with Ring 2.
........................................................................................................................................................................................................................
3
Use the
........................................................................................................................................................................................................................
4
Click on the
........................................................................................................................................................................................................................
5
Double Click on a path; e.g.,
........................................................................................................................................................................................................................
6
Observe the
........................................................................................................................................................................................................................
7
Protection Switch Mode
In the
........................................................................................................................................................................................................................
8
Apply
Click
Result:
indication.
............................................................................................................................................................................................................................................................
6 - 5 2
An STS-1 cross-connect should still exist from the previous tests.
GUI
to view the path protection command.
Each cross-connect that was entered will have an active path associated with it
GUI
to enter the manual path protection switch command.
Fault -> Protection Switch -> Path Protection.
Path m1-1-1
Active Path
displayed.
to issue the command.
The Response Window should display the command followed by a COMPLD
View -> Protection -> Path Protection
.
pull down window select
Manual switching tests
®
GUI and verify proper
command.
Manual
.
365-372-603R2.0
Issue 1 January 2009
Advertisement
Table of Contents
