Table of Contents
Advertisement
Cable and fiber installation
............................................................................................................................................................................................................................................................
Figure 3-14 Sync cable connections
........................................................................................................................................................................................................................
2
Route the cable to proper location and cut to desire length.
........................................................................................................................................................................................................................
3
Terminate the wires in the red jacket for an output signal. See
"Synchronization cable (DS1 timing reference) connections" (p. 3-56)
information.
........................................................................................................................................................................................................................
4
Terminate the wires in the gray jacket for an input signal. See
"Synchronization cable (DS1 timing reference) connections" (p. 3-56)
information.
........................................................................................................................................................................................................................
5
Repeat
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
Sync cable with wire-wrap DB-9 connector procedure
Perform the following steps when using the Sync cable with the wire-wrap DB-9
connector.
........................................................................................................................................................................................................................
1
Connect the wire-wrap DB-9 connector to SYNC1 (J11). Refer to
cable connections" (p.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
Step 1
through
Step 4
S
F
T E P S
3-53).
to connect the Sync cable to the SYNC2 (J12) port.
"Installation checklist" (p.
Sync cable installation
Table 3-18,
for connection
Table 3-18,
for connection
I-6).
Figure 3-14, "Sync
3 - 5 3
Advertisement
Table of Contents
