............................................................................................................................................................................................................................................................

Place the circuit pack into the shelf (slot D2 or G2 as required).

Repeat

equipped with LNW49 circuit packs.

Check off the appropriate box in

N D

........................................................................................................................................................

LNW31 (OC-48 OLIU) low-speed installation (optional)

Follow this procedure only if installing LNW31 (OC-48 OLIU) circuit packs into the

Alcatel-Lucent 1850 TSS-60 shelf.

Refer to the engineering job specification. Identify the proper function group(s) and/or

growth slot(s) where LNW31 circuit pack will be installed.

Remove the LNW31 from the packing material.

Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the

circuit pack in the backplane connector.

If a companion circuit pack is required, continue with the

LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then

proceed to

Note:

provide proper air flow for cooling.

Remove the second LNW31 from the packing material.

Place the circuit pack into the shelf (slot D2 or G2 as required).

365-372-603R2.0

Issue 1 January 2009

Step 1

through

Step 6

T E P S

Step

177D or LNW98 Apparatus Blanks are required in all unused slots D and G to

for each additional function group and/or growth slot to be

"Installation checklist" (p.

Initial circuit pack installation

I-6).

Step

5. If not, install a 177D or

4 - 2 3

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 165

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents