Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 167

Transport service switch
Table of Contents

Advertisement

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
LNW63 (GBE PL) 4 port or LNW64 (GBE PL) 8-port installation (optional)
Follow this procedure only if installing LNW63 (GBE PL) 4 port or LNW64 (GBE PL) 8
port circuit packs into the Alcatel-Lucent 1850 TSS-60 shelf.
Note:
LX or SX PTM.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group slot (D1 or
G1) where the LNW63 or LNW64 circuit pack will be installed.
Note:
group unless the LNW141 or LNW84 VLF main OLIU is used. See the Alcatel-Lucent
1850 Transport Service Switch (TSS-60) Release 2.0 Product Information and
Planning Guide — 365-372-600R2.0 for allowed combinations.
........................................................................................................................................................................................................................
2
Remove the LNW63 or LNW64 circuit pack from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Install a 177D or LNW98 Apparatus Blank into the companion circuit pack slot (D2 or G2
as required).
Important!
to provide proper air flow for cooling.
........................................................................................................................................................................................................................
5
Repeat
LNW63 or LNW64 circuit packs.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
S
F
T E P S
The LNW63 (GBE PL) 4 port or LNW64 (GBE PL) 8 port requires either a
LNW63 or LNW64 circuit pack can only be installed in slot 1 of any function
177D or LNW98 Apparatus Blanks are required in all unused slots D and G
Step 1
through
Step 4
"Installation checklist" (p.
for each additional function group to be equipped with
Initial circuit pack installation
I-6).
4 - 2 5

Advertisement

Table of Contents
loading

Table of Contents