Fiber Spools - Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual

Physical installation
............................................................................................................................................................................................................................................................
Figure 2-8 Fiber spools
........................................................................................................................................................................................................................
12
Verify with an ohmmeter that the Alcatel-Lucent 1850 TSS-60 shelf is grounded to the
bay frame. Measure between the Alcatel-Lucent 1850 TSS-60 shelf mounting bracket and
the office ground lug on the bay frame.
Requirement: The ohmmeter reads less than 1 ohm.
........................................................................................................................................................................................................................
13
Verify with an ohmmeter that the ESD Jack Stud mounted at the rear of the shelf is
grounded to the bay frame. Measure between the ESD Jack Stud and the office ground lug
on the bay frame.
Requirement: The ohmmeter reads less than 1 ohm.
........................................................................................................................................................................................................................
14
Check off the appropriate box in
E O
N D
........................................................................................................................................................
Heat baffle
........................................................................................................................................................................................................................
1
If the Alcatel-Lucent 1850 TSS-60 shelf is to be installed above or below existing
equipment that does not have a heat baffle, then a heat baffle (C848862181) must be
installed between the shelf and the existing equipment.
........................................................................................................................................................................................................................
2
If there is space left in the bayframe above the last Alcatel-Lucent 1850 TSS-60 shelf
installed, a heat baffle must be installed above the shelf to prevent accidental damage to
the power cables at the top of the shelf.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
S
F T E P S
Alcatel-Lucent 1850 TSS-60 shelf installation
"Installation checklist" (p. I-6).
2 - 1 5