Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
2
Choose the DS1/E1 port to test and click
........................................................................................................................................................................................................................
3
Select
........................................................................................................................................................................................................................
4
Once the loopback is up, a test signal shall be generated at the DS1/E1 terminating
equipment which will verify that the cabling is correct.
Note:
loopback.
........................................................................................................................................................................................................................
5
Once the test is complete, remove the loopback.
Select Fault -> Analysis -> Loopback
........................................................................................................................................................................................................................
6
Choose the DS1/E1 port to test and click Select.
........................................................................................................................................................................................................................
7
Select
........................................................................................................................................................................................................................
8
Repeat
........................................................................................................................................................................................................................
9
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
6 - 1 6
Operate
Loopback Type: Facility
and
A test set can be applied at the DSX-1 to test cabling toward the facility
Release
Loopback Type: Facility
and
Step 1
through
Step 7
S
F
T E P S
Select
.
and click
...
and click
for each DS1/E1 cabled to the DSX-1.
"Installation checklist" (p.
Apply
.
Apply
.
II-5).
Issue 1 January 2009
DS1/E1 testing
365-372-603R2.0
Advertisement
Table of Contents
