............................................................................................................................................................................................................................................................

Enter the Frequency in the Expected Frequency and click Apply, then Close.

Note:

column in

Create OCH Cross-connections

Select Configuration --> OCH Cross-connections from the System View

Select the Create a new OCH cross-connection radio button in the OCH

Cross-Connection Wizard. Click Next.

Click the 2-way Add/Drop radio button from the cross-connection list. Click Next.

Click Select and expand the circuit pack list by clicking the "+" next to Main 1, highlight

Port 1 OTU-2 and the port will appear on the right side of the screen, click on the AID to

highlight it then click Select.

Click Select for the Add/Drop port, expand the circuit pack (OMD5/8) and click on the

Port (the port must match Main 1 OTU-2 port) and the port will appear on the right side of

the screen, click on the AID to highlight it then click Select.

Connect the fibers from Main 1/Main2 PTM to the corresponding channel in the LNW785

while observing proper optical levels, fiber cleaning procedures and fiber routing in the

shelf.

Repeat

Result:

alarms cleared between the nodes.

If configuring the other direction, repeat

365-372-603R2.0

Issue 1 January 2009

The frequency is determined by the PTM inserted in Port 9. See the LNW785

Table 8-1, "Channel/port assignments" (p. 8-11)

Step 16

Step 28

at the other end of the circuit.

Once both ends are completed the Mains should go into service and LOS

Connecting the ring (Mains) to the WDMX

Step 16

Step

28.

for acceptable values.

8 - 7

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 291

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents