............................................................................................................................................................................................................................................................

Remove the optical fiber jumper from the OC-3 OLIU (at the LGX).

Result:

and NE LEDs should be lit on the SYSCTL circuit pack.

If not still connected from the previous procedure. Connect the Front CIT cable between

the PC and the CIT/RS 232 port or OSI front LAN port of the System Controller and login

to the shelf using the serial/LAN connection and the GUI options on WaveStar

Use the GUI window to send the

Click on the

Result:

There should be no alarm indications on the Alcatel-Lucent 1850 TSS-60 shelf.

Remove PTM if necessary and the 15-dB LBO from OC-3 OLIU from (port 1) and plug it

into the IN connector directly below it (port 2).

Connect the fibers labeled IN and OUT from the LGX to the OLIU (port 2).

Connect the Port 2 IN connector to the Port 2 OUT connector (at the LGX) of the OC-3

OLIU, using an optical fiber jumper cable.

Result:

LEDs should be lit on the SYSCTL circuit pack.

After approximately 20 seconds the flashing FAULT LED should extinguish on the

OC-3 OLIU and the FAULT, MJ and NE LEDs should be lit on the SYSCTL circuit

pack.

Repeat

Repeat this entire procedure for each LNW37 PTM equipped in the Alcatel-Lucent 1850

TSS-60 shelf.

365-372-603R2.0

Issue 1 January 2009

The FAULT LED should begin flashing on the OC-3 OLIU and only the MN

Configuration -> Update System -> Update All

The flashing FAULT LED should extinguish on the OC-3 OLIU.

The FAULT LED on the OC-3 OLIU will begin flashing and the MN and NE

Step 2

Step 9

for OLIU ports 3 and 4.

upd-sys

command.

OC-3 low-speed testing

CIT.

6 - 2 9

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 223

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents