............................................................................................................................................................................................................................................................

Check off the appropriate box in

N D

........................................................................................................................................................

LNW78 (4 GIGE ports and 4 Optical 100 BaseLX -RPR)

Follow this procedure only if installing LNW78 circuit packs into the Alcatel-Lucent 1850

TSS-60 shelf.

Note:

When inserting them into ports provision the card appropriately.

Refer to the engineering job specification. Identify the proper function group slot (D1 or

G1) where the LNW78 circuit pack will be installed.

Note:

unless the LNW141 or LNW84 VLF main OLIU is used. See the Alcatel-Lucent 1850

Transport Service Switch (TSS-60) Release 2.0 Product Information and Planning

Guide — 365-372-600R2.0 for allowed combinations.

Remove the LNW78 from the packing material.

Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the

circuit pack in the backplane connector.

Install a 177D or LNW98 Apparatus Blank into the companion circuit pack slot (D2 or G2

as required).

Important!

to provide proper air flow for cooling.

Repeat

LNW78 circuit packs.

365-372-603R2.0

Issue 1 January 2009

T E P S

The LNW78 supports both electrical and optical PTMs, for both gigE and FE.

LNW78 circuit pack can only be installed in slot 1 of any function group

177D or LNW98 Apparatus Blanks are required in all unused slots D and G

Step 1

through

Step 4

"Installation checklist" (p.

for each additional function group to be equipped with

Initial circuit pack installation

I-6).

4 - 2 7

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 169

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents