............................................................................................................................................................................................................................................................

Result:

LEDs should be lit on the SYSCTL circuit pack.

After approximately 20 seconds the flashing FAULT LED should extinguish on the

OC-3 OLIU and the FAULT, MJ and NE LEDs should be lit on the SYSCTL circuit

pack.

Repeat

circuit packs.

Repeat this entire procedure for each LNW45 and LNW55 equipped in the Alcatel-Lucent

1850 TSS-60 shelf.

Replace all protective dust covers on the LNW45 and LNW55 PTM connectors (OLIU

and LGX), that were removed to perform this procedure.

Check off the appropriate box in

N D

........................................................................................................................................................

6 - 3 2

The FAULT LED on the OC-3 OLIU will begin flashing and the MN and NE

Step 2

Step 10

for OLIU for the remaining ports on the LNW45 and the LNW55

T E P S

"Installation checklist" (p.

OC-3 low-speed testing

II-5).

365-372-603R2.0

Issue 1 January 2009

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 226

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents