Table of Contents
Advertisement
Stand-alone installation testing
............................................................................................................................................................................................................................................................
LED test
Description
This test verifies proper operation of all LEDs on the Alcatel-Lucent 1850 TSS-60 circuit
packs. Operation of all the LEDs is necessary to assist in trouble isolation.
Note:
or shelf and replace the faulty unit.
Procedure
Proceed as follows:
........................................................................................................................................................................................................................
1
If not still connected from the previous procedure. Connect the Front CIT cable between
the PC and the CIT/RS 232 port or OSI front LAN port of the System Controller and login
to the shelf using the serial/LAN connection and the GUI options on WaveStar
........................................................................................................................................................................................................................
2
Use the
........................................................................................................................................................................................................................
3
Click on the
........................................................................................................................................................................................................................
4
Select Shelf (
........................................................................................................................................................................................................................
5
Select.
Click
........................................................................................................................................................................................................................
6
Number of Iterations = 1
Click
........................................................................................................................................................................................................................
7
Click OK.
Result:
seconds, and then the proper LEDs will light to indicate the current status of the shelf.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
If there are any LED failures, determine if the problem is with the circuit pack
GUI
window to send the
Fault -> Test -> LED.
Alcatel-Lucent 1850 TSS-60
All LEDs on the shelf should light for 10 seconds, then extinguish for 10
Test-LED
command.
).
.
LED test
®
CIT.
6 - 4 1
Advertisement
Table of Contents
