............................................................................................................................................................................................................................................................

LNW74 and LNW66 testing

LNW74 (10/100), LNW66 (10/100T) TX Ethernet cabling testing

This procedure is to test the Ethernet 10/100 TX cabling from function groups D and G to

the RJ45 patch panel for use with the LNW74(10/100) or the LNW66 (10/100T)

The following cables are required to test the Ethernet cabling.

Cable

Front CIT(RS-232) Cable

(C848748869)

LAN 10BaseT Straight-through

Cable

Ethernet port assignment verification testing

Connect the Front CIT cable between the PC and the CIT/RS 232 port of the System

Controller and login to the shelf using the serial connection and the GUI options on

WaveStar

Identify the function groups that contain LNW74 or LNW66 circuit packs with cabling for

testing.

Identify the RJ45 patch panel associated with the function groups identified above.

Connect the RJ45 cable from the first RJ45 on the patch panel to the Ethernet port on your

PC.

Watch for the link LED to light on the PC's Ethernet card or wait for 30 seconds and then

disconnect the RJ45 cable from the patch panel.

The Fault LED will start flashing on the LNW74 or LNW66 and the GUI will alarm the

port under test and display a Critical Alarm inc.FE-LAN LOS in the Alarm List.

6 - 2 4

CIT.

Length

8'-0"

As required to reach

from front of

Alcatel-Lucent 1850

TSS-60 to the RJ45

patch panel

LNW74 and LNW66 testing

Quantity

365-372-603R2.0

Issue 1 January 2009

Table of Contents

Lnw74 And Lnw66 Testing - Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual

LNW74 and LNW66 testing

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Content for Alcatel-Lucent 1850 TSS-60

Table of Contents