Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 161

Transport service switch
Table of Contents

Advertisement

Circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot D2 or G2 as required).
........................................................................................................................................................................................................................
7
Repeat
equipped with LNW37 or LNW45 circuit packs.
........................................................................................................................................................................................................................
8
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
LNW49 (OC-12 4 port PTM OLIU) low speed installation (optional)
Follow this procedure only if installing the LNW49 (OC-12 4 port PTM OLIU) circuit
packs into the Alcatel-Lucent 1850 TSS-60 shelf.
Note:
boxes. One box containing the circuit pack, the other containing the ordered quantity
of PTMs. This procedure will consist of two parts.
– Install the circuit card.
– Install the PTM.
........................................................................................................................................................................................................................
1
Refer to the engineering job specification. Identify the proper function group(s) and/or
growth slot(s) where LNW49 circuit pack will be installed.
........................................................................................................................................................................................................................
2
Remove the LNW49 from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot D1 or G1 as required). Do NOT engage the
circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with the
LNW98 Apparatus Blank into the protection circuit pack slot (D2 or G2 as required), then
proceed to
Note:
provide proper air flow for cooling.
............................................................................................................................................................................................................................................................
365-372-603R2.0
Issue 1 January 2009
Step 1
through
Step 6
S
F
T E P S
The LNW49 (OC-12 4 port PTM OLIU) circuit pack comes in two separate
Step
7.
177D or LNW98 Apparatus Blanks are required in all unused slots D and G to
for each additional function group and/or growth slot to be
"Installation checklist" (p.
Initial circuit pack installation
I-6).
Step
5. If not, install a 177D or
4 - 1 9

Advertisement

Table of Contents
loading

Table of Contents