............................................................................................................................................................................................................................................................

Click Select for the Add/Drop port, expand the circuit pack (OMD5/8) and click on the

Port and the port will appear on the right side of the screen, click on the Port to highlight

it then click Select.

Note:

Click Next, then Finish and complete the cross-connection by clicking on Yes in the

confirmation window.

Connect fibers from Test port to selected channel on LNW785, while observing optical

power requirements and cleaning procedures.

Repeat

Connect the Transmit fibers on the LNW785 at each end, following proper fiber cleaning

procedures.

Connect the Receive fibers on the LNW785 at each end, while observing optical power

requirements and cleaning procedures.

Result:

If adding a span in the other direction using the LNW785 repeat

otherwise continue.

Perform end-to-end testing. Follow the end to end testing procedures determined by the

input test signal. If the test signal is the Alcatel-Lucent 1850 TSS-60 as part of a ring,

proceed to

appropriate procedure

Check off the appropriate box in the

365-372-603R2.0

Issue 1 January 2009

The port is determined by the test signal wavelength documented in

Step 2

Step 9

at the remote Network Element.

Span is in-service

Chapter 8, "WDMX setup and testing: integration procedures"

Turn-up and test the LNW785 8 channel OMD

"Installation checklist" (p.

Step

Step 1

through

Step

12,

and locate the

III-4).

8 - 5

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 289

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents