............................................................................................................................................................................................................................................................

Note:

Splice feeders from the BDCBB or BDFB to the Alcatel-Lucent 1850 TSS-60 power

cable. Refer to

follows;

Note:

1. BAT A

2. BAT A RTN

3. BAT B

4. BAT B RTN

Note:

arrangements and 15 amperes for a single shelf.

Leave the BDCBB breakers off or BDFB fuses out until you are ready to perform the

procedures in

Check off the appropriate box in

N D

........................................................................................................................................................

2 - 1 8

The Alcatel-Lucent 1850 TSS-60 is powered by -48 V DC.

CAUTION

Verify that the BDCBB breakers are off or that the BDFB fuses are not installed.

Table 2-3, "Power connections" (p.

Four wires are spliced to the power cables.

Each feeder at the BDCBB or BDFB should be fused for 25 amperes for bay

Chapter 4, "Circuit pack installation"

T E P S

2-19). and should be labeled as

of this manual.

"Installation checklist" (p.

Power cable installation

I-6).

365-372-603R2.0

Issue 1 January 2009

Table of Contents

Alcatel-Lucent 1850 TSS-60 Installation And System Turn-Up Manual page 64

Related Manuals for Alcatel-Lucent 1850 TSS-60

Related Products for Alcatel-Lucent 1850 TSS-60

Table of Contents