Table of Contents
Advertisement
Circuit pack installation
............................................................................................................................................................................................................................................................
Description
Overview
This section should be performed on all shelf installations.
Tools, test equipment, and accessories
Listed below are the tools, test equipment and accessories necessary to perform the
procedures in this section.
Quantity
1
1
1
1
............................................................................................................................................................................................................................................................
4 - 2
Description
Screwdriver(s)
ESD Wrist Strap
Multimeter (Optional)
Personal Computer (PC)
CIT RS-232 Interface
Cable
Comments
A screwdriver(s) with the appropriate head(s) is
(are) required for securing the mounting screws,
repositioning the mounting brackets, installing the
interfacing cables, and for setting the circuit
breakers to the OFF position.
A wrist strap must be worn when handling circuit
packs. Use the electrostatic discharge (ESD) jack
provided on the shelf.
The voltmeter must be capable of measuring DC
voltage in the 40- to 60-volt range. The use of the
voltmeter is optional since the shelf will alarm or
shut down if the proper voltage is not supplied.
Required to run the WaveStar
8-ft. long RJ45 to 9-pin D-sub serial cable
(Comcode 848748869). Required to connect the
PC to the CIT jack on the front of the SYSCTL
circuit pack.
Description
®
CIT software.
365-372-603R2.0
Issue 1 January 2009
Advertisement
Table of Contents
