Lan Cross-Over Cable Connections; Lan Straight-Through Cable Connections - Alcatel-Lucent 1850 Installation And System Turn-Up Manual

Transport service switch (tss-5) | release 5.1
Hide thumbs Also See for 1850:
Table of Contents

Advertisement

Cable and fiber installation
............................................................................................................................................................................................................................................................
Table 3-21 LAN straight-through cable connections
SYSCTL
Connection
LAN
Procedure
Proceed as follows:
........................................................................................................................................................................................................................
1
Connect the cable to the LAN (RJ-45) jack on the SYSCTL VLNC2, or VLNC40/42
MGMT LAN, or the VLNC60/61 MGMT LAN, or the VLNC64 MGMT LAN circuit
pack.
Note:
Table 3-20, "LAN cross-over cable connections" (p.
Note:
Table 3-21, "LAN straight-through cable connections" (p.
........................................................................................................................................................................................................................
2
Check off the appropriate box in
E
O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
3 - 3 6
Alcatel-Lucent
1850 TSS-5
1
2
3
6
If connecting directly to a PC, use a LAN cross-over cable assembly (see
If connecting to a hub, use a LAN straight-through cable assembly (see
Are you using...
Cross-over LAN cable
Straight-through LAN cable
S
F
T E P S
Design
Color
to HUB
TX+
BL - W
1
TX-
W - BL
2
RCV+
O - W
3
RCV-
W - O
6
Then...
Route the cable to the desired PC LAN
Network Interface card
Route the cable to the desired hub port
location
Table I-1, "Part I installation checklist" (p.
LAN cable installation
Pin
Design
TX+
TX-
RCV+
RCV-
3-35)).
3-36)).
1-3).
365-372-403R5.1
Issue 1 November 2008

Advertisement

Table of Contents
loading

Table of Contents