Connections - Nortel Communication Server 1000 Manual

Connections

Connection checklist
Table 9
Connections checklist
Do you have:
A serial cable (DTE-DTE null modem cable) to connect the server to a maintenance
terminal? The IBM x3350 requires a NTRX26NPE6 9 pin female to 9 pin female null
modem cable.
NTAK19EC cable (if you are connecting a Nortel CP PM)? This cable adapts the 50-pin
MDF connector on the back of the shelf of the Media Gateway, Universal Equipment
Module, or 11C cabinet to a 25-pin DB connector.
CAT5 cables (or better) to connect the server to the ELAN and TLAN subnets?
Communication Server 1000M and Meridian 1
This section contains connection information.
WARNING
Do not modify or use a supplied AC power cord if it is not
the correct type required for the host region.
Nortel CP PM servers are powered through the backplane of the Media
Gateway, Universal Equipment Module, or 11C cabinet into which they
are installed and do not require a power cord.
Before connecting a CP PM or COTS server, ensure that you have the
following materials on-hand.
Installing a CP PM or COTS server
IMPORTANT!
61C CP PII to CS 1000M MG CP PIV FNF Up-
Page 157 of 196