Displaying Rf Auto-Tuning Information; Displaying Rf Auto-Tuning Settings - 3Com WX1200 3CRWX120695A Configuration Manual

Displaying
RF Auto-Tuning
Information
Displaying
RF Auto-Tuning
Settings
WX# display radio-profile default
Beacon Interval:
Max Tx Lifetime:
RTS Threshold:
Long Preamble:
Tune Channel Range (11a):
Tune Power:
Tune Power Interval:
Channel Holddown:
Active-Scan:
WMM Powersave:
Rate Enforcement:
ETT Link Factor:
Dwell Time:
Intial Measur Interval:
Radio Link Timeout:
To verify the static settings, use the
To save the locked down settings, you must save the switch's configuration.
The following commands lock down the channel and power settings for
radios in radio profile rp2:
WX1200# set radio-profile rp2 auto-tune channel-lockdown
success: change accepted.
WX1200# set radio-profile rp2 auto-tune power-lockdown
success: change accepted.
You can display the RF Auto-Tuning configuration, a list of RF neighbors,
and the values of RF attributes.
(For information about the fields in the output, see the
Switch and Controller Command
To display the RF Auto-Tuning settings that you can configure in a radio
profile, use the following command:
display radio-profile {name | ?}
Entering display radio-profile ? displays a list of radio profiles.
To display the RF Auto-Tuning and other settings in the default radio
profile, type the following command:
100
2000
2346
no
lower-bands
no
600
300
yes
no
no
3600
60

Displaying RF Auto-Tuning Information

display {ap | dap} config
Reference.)
DTIM Interval:
Max Rx Lifetime:
Frag Threshold:
Tune Channel:
Ignore Clients:
Tune Channel Interval:
Power ramp interval:
Countermeasures:
RFID enabled:
QoS Mode:
Initial Load:
3 Change Threshold:
Probe Interval:
Maximum Measure Interval:
5
319
command.
Wireless LAN
1
2000
2346
yes
no
3600
60
none
no
wmm
1000
25
60
600