3Com WX1200 3CRWX120695A Configuration Manual page 294

294 C 13: C
HAPTER ONFIGURING
WX1200# display service-profile sp1
ssid-name:
Beacon:
DHCP restrict:
Short retry limit:
Auth fallthru:
Enforce SODA checks:
Custom success web-page:
Custom logout web-page:
Static COS:
CAC mode:
User idle timeout:
Keep initial vlan:
Web Portal ACL:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip, cipher-wep40
authentication: 802.1X
TKIP countermeasures time: 30000ms
11a beacon rate:
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate:
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate:
11g mandatory rate: 1.0,2.0,5.5,11.0 standard rates: 6.0,9.0,12.0,18.0,24.0,
36.0,48.0,54.0
U E
SER NCRYPTION
Displaying WPA Settings
To display the WPA settings in a service profile, use the following
command:
display service-profile {name | ?}
To display the WPA settings in effect in service profile wpa, type the
following command:
private
yes
none
yes
none
180
<none>
<none>
6.0
2.0
2.0
The WPA settings appear at the bottom of the output.
The WPA fields appear in the display service-profile output only when
WPA is enabled.
ssid-type:
Proxy ARP:
no No broadcast:
5 Long retry limit:
Sygate On-Demand (SODA):
SODA remediation ACL:
Custom failure web-page:
Custom agent-directory:
no COS:
CAC sessions:
Idle client probing:
no Web Portal Session Timeout:
WEP Key 2 value:
WEP Key 4 value:
1 WEP Multicast Index:
NO
multicast rate:
multicast rate:
multicast rate:
crypto
no
no
5
no
0
14
yes
5
<none>
<none>
1
AUTO
AUTO
AUTO