Displaying Port Information - 3Com WX1200 3CRWX120695A Configuration Manual

Displaying Port
Information
WX1200# display port status
Port Name
===============================================================================
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
Resetting a Port
You can reset a port by toggling its link state and PoE state. MSS disables the
port's link and PoE (if applicable) for at least one second, then reenables
them. This feature is useful for forcing a MAP that is connected to two WX
switches to reboot using the port connected to the other switch.
To reset a port, use the following command:
reset port port-list
You can use CLI commands to display the following port information:
Port configuration and status
PoE state
Port statistics
You also can configure MSS to display and regularly update port statistics
in a separate window.
Displaying Port Configuration and Status
To display port configuration and status information, use the following
command:
display port status [port-list]
To display information for all ports, type the following command:
Admin Oper
up up
up down
up down
up down
up up
up up
up down
up down
In this example, three of the switch's ports, 1, 5, and 6, have an
operational status of up, indicating the links on the ports are available.
Ports 1 and 6 are network ports. Port 5 is a MAP access port.
(For more information about the fields in the output, see the
LAN Switch and Controller Command
Configuring and Managing Ports
Config Actual
auto 100/full
auto
auto
auto
auto 100/full
auto 100/full
auto
auto
Reference.)
Type Media
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
ap 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
network 10/100BaseTx
Wireless
81