Configuring A Client Black List - 3Com WX1200 3CRWX120695A Configuration Manual

Configuring a Client
Black List
The following command clears SSID mycorp from the permitted SSID list:
WX1200# clear rfdetect ssid-list mycorp
success: mycorp is no longer in ssid-list.
The client black list specifies clients that are not allowed on the network.
MSS drops all packets from the clients on the black list.
By default, the client black list is empty. In addition to manually
configured entries, the list can contain entries added by MSS. MSS can
place a client in the black list due to an association, reassociation or
disassociation flood from the client.
The client black list applies only to the WX switch on which the list is
configured. WX switches do not share client black lists.
To add an entry to the list, use the following command:
set rfdetect black-list mac-addr
The following command adds client MAC address 11:22:33:44:55:66 to
the black list:
WX1200# set rfdetect black-list 11:22:33:44:55:66
success: MAC 11:22:33:44:55:66 is now blacklisted.
To display the client black list, use the following command:
display rfdetect black-list
The following example shows the client black list on WX switch:
WX1200# display rfdetect black-list
Total number of entries: 1
Blacklist MAC
----------------- ----------------- ------- ---
11:22:33:44:55:66 configured
11:23:34:45:56:67 assoc req flood
To remove a MAC address from the client black list, use the following command:
clear rfdetect black-list mac-addr
The following command removes MAC address 11:22:33:44:55:66 from
the black list:
WX1200# clear rfdetect black-list 11:22:33:44:55:66
success: 11:22:33:44:55:66 is no longer blacklisted.
Configuring Rogue Detection Lists
Type Port
-
3
577
TTL
-
25