Configuring A Port Name - 3Com WX1200 3CRWX120695A Configuration Manual

Configuring and Managing Ports 77
A cleared port is not placed in any VLANs, not even the default VLAN
(VLAN 1).
To clear a port, use the following command:
clear port type port-list
For example, to clear the port-related settings from port 5 and reset the
port as a network port, type the following command:
WX1200# clear port type 5
This may disrupt currently authenticated users. Are you sure?
(y/n) [n]y
success: change accepted.
Clearing a Distributed MAP
To clear a Distributed MAP, use the following command:
clear ap apnumber
Configuring a Port Each WX switch port has a number but does not have a name by default.
Name
Setting a Port Name
To set a port name, use the following command:
set port port name name
You can specify only a single port number with the command.
To set the name of port 2 to adminpool, type the following command:
WX1200# set port 2 name adminpool
success: change accepted.
To avoid confusion, 3Com recommends that you do not use numbers as
port names.
Removing a Port Name
To remove a port name, use the following command:
clear port port-list name