Displaying And Changing Port Information; Enabling And Disabling Ports - 3Com SuperStack II Manual

120 C 4: W
HAPTER ORKING
Displaying and
Changing Port
Information
Enabling and
Disabling Ports
W C L
ITH THE OMMAND INE
You can display and change information about the ports on the current
Switch unit in the stack using the commands on the Ethernet menu.
These commands allow you to:
Enable and disable Ethernet ports on the Switch
Specify the speed and duplex mode of Ethernet ports on the Switch
Enable and disable auto-negotiation for Ethernet ports on the Switch
Enable and disable IEEE 802.3x flow control for Ethernet ports on the
Switch
Display statistical information about Ethernet ports on the Switch
Display summary information about Ethernet ports on the Switch
To display and change information about the ports on another Switch
unit in the stack, you need to select that unit using the
For more information, see
Interface" on page
You can enable and disable Ethernet ports on the Switch using the
command on the Ethernet menu.
portState
By default, all ports on the Switch are enabled.
To enable or disable a port:
1 At the Top-level menu, enter:
ethernet portState
The following prompt is displayed:
Select Ethernet port(s) (1-24):
2 Enter the number of the port to be enabled or disabled.
The following prompt is displayed:
Enter new value (enable, disable) [enable]:
3 Enter or
enable disable
I
NTERFACE
"Moving the Focus of the Command Line
141.
.
command
unit