290
C
13: C
HAPTER
ONFIGURING
Configuring WPA
U
E
SER
NCRYPTION
Table 24 lists the encryption support for WPA and non-WPA clients.
Table 24 Encryption Support for WPA and Non-WPA Clients
Client Encryption Type
MSS
Encryption
WPA —
Type
CCMP
Supports
WPA —
CCMP
WPA —
TKIP
WPA —
WEP40
WPA —
WEP104
Dynamic
WEP
Static
WEP
To configure MAP radios to support WPA:
1 Create a service profile for each SSID that will support WPA clients.
2 Enable the WPA IE in the service profile.
3 Enable the cipher suites you want to support in the service profile. (TKIP is
enabled by default.) Optionally, you also can change the countermeasures
timer value for TKIP.
4 Map the service profile to the radio profile that will control IEEE settings
for the radios.
5 Assign the radio profile to the radios and enable the radios.
If you plan to use PSK authentication, you also need to enable this
authentication method and enter an ASCII passphrase or a hexadecimal
(raw) key.
WPA —
WPA —
TKIP
WEP40
Supports
Supports
WPA —
Dynamic
WEP104
WEP
Supports
Supports
Supports
Supports
Static
WEP
Supports
Supports