Displaying Static Ip Address Information For Distributed Maps - 3Com WX1200 3CRWX120695A Configuration Manual

WX# display ap status 1
AP: 7, AP model: AP3750, manufacturer 3Com, name: MAP07
====================================================
State: operational (not encrypt)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr, ram=33554432
Uptime: 531 hours, 37 minutes, 28 seconds
Radio 1 type: 802.11g, state: configure succeed [Disabled] (Sweep mode)
operational channel: 1 (Auto) operational power: 1
bssid1: 00:0b:0e:00:ca:c0, ssid: techpubs
bssid2: 00:0b:0e:00:ca:c2, ssid: techpubs-wpa
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
Radio 2 type: 802.11a, state: configure succeed [Disabled] (Sweep mode)
operational channel: 40 (Auto) operational power: 1
bssid1: 00:0b:0e:00:ca:c1, ssid: chloe
load balance: enabled, current load: (unavailable)
RFID Reports: Inactive
Displaying Static IP
Address Information
for Distributed MAPs
The following command displays the status of a Distributed MAP:
s/n=0333703050 hw_rev=A3
(For information about the fields in the output, see the
Switch and Controller Command
To display information about Distributed MAPs that have been
configured with static IP address information, use the following
command:
display ap boot-configuration apnumber
To display statistics counters for Distributed MAP 1, type the following
command:
WX# display ap boot-configuration 1
Static Boot Configuration
AP: 7
IP Address: Disabled
VLAN Tag: Disabled
Switch: Disabled
Mesh: Disabled
IP Address:
Netmask:
Gateway:
VLAN Tag:
Switch IP:
Switch Name:
Displaying MAP Information
Reference.)
261
Wireless LAN