Mobility Domain Scenario - 3Com WX1200 3CRWX120695A Configuration Manual

Mobility Domain
Scenario
The following scenario illustrates how to create a Mobility Domain named
sunflower consisting of three members from a seed WX switch at
192.168.253.21:
1 Make the current WX switch the Mobility Domain seed. Type the
following command:
WX1200# set mobility-domain mode seed domain-name sunflower
success: change accepted.
2 On the seed, add the members of the Mobility Domain. Type the
following commands:
WX1200# set mobility-domain member 192.168.253.11
success: change accepted.
WX1200# set mobility-domain member 192.168.111.112
success: change accepted.
3 For each member WX switch, configure the IP address used to reach the
seed WX switch. Type the following commands:
WX1200# set mobility-domain member seed-ip 192.168.253.21
4 Display the Mobility Domain status. Type the following command:
WX1200# display mobility-domain
Mobility Domain name:
Member
---------------
192.168.111.112
192.168.253.11
192.168.253.21
5 To display the Mobility Domain configuration, type the following
command:
WX1200# display mobility-domain config
This WX is the seed for domain sunflower.
192.168.253.11 is a member
192.168.111.112 is a member
6 To display the WX switches that are hosting VLANs for roaming, type the
following command:
WX1200# display roaming vlan
VLAN
---------------- --------------- --------
vlan-eng
vlan-fin
vlan-pm
sunflower
State
-------------
STATE_UP
STATE_UP
STATE_UP
WX Affinity
192.168.12.7
192.168.15.5
192.168.15.5

Mobility Domain Scenario

Status
--------------
MEMBER
MEMBER
SEED
5
5
5
163