Monitoring The Vlans And Tunnels In A Mobility Domain; Displaying Roaming Stations - 3Com WX1200 3CRWX120695A Configuration Manual

Monitoring the
VLANs and Tunnels
in a Mobility
Domain
Displaying Roaming
Stations
WX1200# display roaming station
User Name
---------------------- ----------------- --------------- -----
example\geetha
nh@example.com
example\tamara
example\jose
hh@example.com

Monitoring the VLANs and Tunnels in a Mobility Domain

Tunnels connect WX switches. Tunnels are formed automatically in a
Mobility Domain to extend a VLAN to the WX switch that a roaming
station is associated with. A single tunnel can carry traffic for many users
and many VLANs. The tunnel port can carry traffic for multiple VLANs by
means of multiple virtual ports.
MSS automatically adds virtual ports to VLANs as needed to preserve the
associations of users to the correct subnet or broadcast domain as they
roam across the Mobility Domain. Although tunnels are formed by IP
between WX switches, the tunnels can carry user traffic of any protocol
type.
MSS provides the following commands to display the roaming and
tunneling of users within their Mobility Domain groups:
display roaming station (See "Displaying Roaming Stations" on
page 159.)
display roaming vlan (See "Displaying Roaming VLANs and Their
Affinities" on page 160.)
display tunnel (See "Displaying Tunnel Information" on page 160.)
The command display roaming station displays a list of the stations
roaming to the WX switch through a VLAN tunnel. To display roaming
stations (clients), type the following command:
Station Address
192.168.15.104
192.168.15.1990
192.168.11.200
192.168.14.200
192.168.15.194
(For more information about this command and the fields in the output,
see the Wireless LAN Switch and Controller Command
VLAN State
vlan-am Up
vlan-am Up
vlan-ds Up
vlan-et Up
vlan-am Up
159
Reference.)