Displaying A Service Profile's Qos Settings - 3Com WX1200 3CRWX120695A Configuration Manual

346 C 16: C
HAPTER ONFIGURING
Tune Power Interval:
Power Backoff Timer:
Active-Scan:
Service profiles: sp1
Displaying a Service
Profile's QoS Settings
WX1200# display service-profile sp1
ssid-name:
Beacon:
DHCP restrict:
Short retry limit:
Auth fallthru:
Enforce SODA checks:
Custom success web-page:
Custom logout web-page:
Static COS:
CAC mode:
User idle timeout:
Web Portal Session Timeout:
WEP Key 1 value:
WEP Key 3 value:
WEP Unicast Index:
Shared Key Auth:
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms
11a beacon rate:
11a mandatory rate: 6.0,12.0,24.0 standard rates: 9.0,18.0,36.0,48.0,54.0
11b beacon rate:
11b mandatory rate: 1.0,2.0 standard rates: 5.5,11.0
11g beacon rate:
11g mandatory rate: 1.0,2.0,5.5,11.0 standard rates: 6.0,9.0,12.0,18.0,24.0,
36.0,48.0,54.0
Q S
UALITY OF ERVICE
600
yes
In this example, the QoS mode is WMM.
(For more information about this command's output, see the "MAP
Commands" chapter in the
Configuration Guide.)
To display QoS settings and all other settings for a service profile, use the
following command:
display service-profile {name | ?}
The following example shows the configuration of the sp1 service profile.
corp2
yes
none
yes
session
180
<none>
<none>
6.0
2.0
2.0
Channel Holddown:
10 Countermeasures:
QoS Mode:
Wireless LAN Switch and Controller
ssid-type:
Proxy ARP:
no No broadcast:
5 Long retry limit:
Sygate On-Demand (SODA):
SODA remediation ACL:
Custom failure web-page:
Custom agent-directory:
no COS:
CAC sessions:
Idle client probing:
5
WEP Key 2 value:
WEP Key 4 value:
1 WEP Multicast Index:
NO
multicast rate:
multicast rate:
multicast rate:
300
none
wmm
crypto
no
no
5
no
0
14
yes
<none>
<none>
1
AUTO
AUTO
AUTO